Lift rust, oil and algae marks from your pavers
Paver Stain Removal in Northside, FL
Call (904) 479-0914 for a free paver stain removal estimate and hear back within 1 business day.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Who removes paver stains in Northside, and how fast do they answer?
A local contractor can treat the stains on your Northside pavers, and a reply comes within 1 business day, usually much sooner. The estimate is free with no obligation. To start, call (904) 479-0914.
A stain on pavers is rarely just dirt. Rust, oil, algae and white haze each need their own treatment, and the wrong one can set the mark in. A contractor who identifies the stain first can lift it and leave the surface even. Describe the color, the spot and how long it has been there, and send a photo of the worst area or get a free estimate.
What kind of stain is on my pavers?
Colors give the first clue. Orange or rust red points to iron. Dark spots under a car point to oil. White chalky haze points to a mineral deposit, and black or green patches in shade point to organic growth. Match yours to this list, then describe it when you call (904) 479-0914.
Orange or rust red
Iron from well water, reclaimed irrigation or fertilizer pellets. It needs a rust remover, not pressure.
Dark and greasy
Oil or grease from vehicles. A degreaser has to sit on it before rinsing.
White and chalky
Efflorescence, a mineral deposit, or old sealer turning hazy. The cleaner differs for each.
Black or green
Algae and mildew from damp shade. It is killed with chemistry, not blasted away.
Why do my pavers have orange stains near the sprinklers?
Iron in the water is the cause. Safe Touch says well water and reclaimed irrigation leave orange stains on concrete, garage doors and stucco, and its advice is that more pressure makes it worse and a rust treatment then a rinse is the fix. Stallone's Pro Wash lists fertilizer pellets as another source. To have a stain looked at, call (904) 479-0914.
Many Northside lots run irrigation off a private well. A regional water management district release says its restrictions cover private well water too: odd addresses water Wednesday and Saturday, even addresses Thursday and Sunday, before 10 a.m. or after 4 p.m. A timer that overshoots the pavers keeps feeding the stain. To get the spray pattern checked with the stain, get a free estimate.
Does bleach take rust off pavers?
No. Stallone's Pro Wash says bleach does nothing for rust and can even set it. Its answer is a paver safe rust remover that dissolves the iron. Safe Touch uses a test area first on painted surfaces and says a rinse follows the treatment. Ask what the contractor brings before the visit, and call (904) 479-0914 if the answer is bleach.
Can oil and grease stains be removed from pavers?
Often they can be lightened, and sometimes fully lifted, if treated while fresh. Stallone's Pro Wash pretreats with a degreaser, lets it dwell, then rinses hot. Coastal Clean Pressure is more careful, calling oil best effort and noting deep oil can leave a lasting mark. A fair contractor tells you which outcome is likely before starting. Send a photo when you get a free estimate.
What are the white patches on my pavers, and are they stains?
They are usually efflorescence, a salt or mineral deposit pushed up through the stone. Stallone's Pro Wash treats it with an acid based cleaner made for the job, then neutralizes and rinses before any sealing. Old sealer that has gone milky can look the same, and Stallone's strips that instead. Show the contractor the patch when you call (904) 479-0914.
How do I get rid of black and green patches for good?
Kill the growth, then change what feeds it. Coastal Clean Pressure treats algae and dark buildup with algaecide, and Safe Touch says soft washing kills growth rather than blasting it off for a while. Humidity and river moisture feed it, and the Northside has plenty of both with the Trout River inside its borders. Call (904) 479-0914 to book a look.
Fresh sand in the joints and a sealer afterward slow the return, though Coastal Clean Pressure is clear that cleaning alone does not protect the surface. Shade is the stubborn part. Note which corners stay wet when you get a free estimate.
Do stains trapped under old sealer need a different process?
Yes, the sealer has to come off first. Stallone's Pro Wash lists dark trapped stains as one of six signs that a sealer has failed, along with peeling, flaking, yellowing and milky patches. Stripping runs through a test spot, stripper, rinse and a neutralizing step. New sealer goes on only when the surface is fully dry. To ask about a stain under a coat, call (904) 479-0914.
What does paver stain removal cost in Northside?
No page found lists a price for stain treatment alone, so the table builds a range from published pieces. Stallone's Pro Wash starts cleaning at $0.22 per square foot. Hydro Wash 360 lists stripping at $0.75 to $1.50 and Safe Touch lists $1.75 to $3.25 to clean, sand and seal. To get a price for your marks, get a free estimate.
A single rust fan from a sprinkler is a small job and a driveway full of oil is a larger one, so the contractor sets the figure after seeing it. Hydro Wash 360 adds that bids under $1 per square foot skip prep. Call (904) 479-0914 with the size and the stain type.
| Paved area | Wash alone, from $0.22 | Add stripping if the stain is under old sealer | Clean, sand and seal |
|---|---|---|---|
| 300 sq ft | $66 | $225 to $450 | $525 to $975 |
| 600 sq ft | $132 | $450 to $900 | $1,050 to $1,950 |
| 1,000 sq ft | $220 | $750 to $1,500 | $1,750 to $3,250 |
No page found publishes a rate for stain treatment alone. This table uses the published pieces around it: a $0.22 per square foot starting rate for cleaning (Stallone's Pro Wash), $0.75 to $1.50 to strip old sealer (Hydro Wash 360, 2026) and $1.75 to $3.25 to clean, sand and seal (Safe Touch, November 2026). A rust or oil treatment is priced on site.
How do I keep stains from coming back?
Fix the source and keep a coat on. For rust, that means aiming sprinkler heads off the pavers and keeping fertilizer pellets swept up. For oil, it means a drip pan under a leaking car. Stallone's Pro Wash says to clean at least once a year and twice for shaded or pool side pavers. For a yearly plan, call (904) 479-0914.
A sealer, which lasts 2 to 5 years per Stallone's, slows how fast liquids soak in. It does not make pavers stain proof. Ask how the finish handles oil when you get a free estimate.
What do cleaned pavers look like after stain treatment?
Common questions about paver stain removal
How much is it to clean pavers?
Cleaning starts around $0.22 per square foot, per Stallone's Pro Wash, so a 600 square foot driveway begins near $132. Treating a rust or oil stain is priced on site. Clean, sand and seal runs $1.75 to $3.25 per square foot at published rates.
Is it good to seal pavers in Florida?
Yes, once the stains are gone. A sealed surface rinses easier and can slow new stains from soaking in. Sealing over a stain traps it, so the stain treatment comes first.
How do I clean concrete paver stains?
The product depends on the stain, so a contractor matches them. Stallone's Pro Wash uses a degreaser for oil, a paver safe rust remover for orange marks and an acid based cleaner, neutralized after, for white haze. Ask what will be used on yours.
What should you not use to clean pavers?
Bleach on rust is the classic mistake. Stallone's Pro Wash says it does nothing for rust and can set it. Safe Touch adds that more pressure makes rust worse. Hard blasting also pushes sand out of the joints.
What are the orange stains on my pavers from?
Most likely iron. Safe Touch says well water and reclaimed irrigation leave orange rust marks, and Stallone's Pro Wash adds fertilizer pellets. A rust treatment then a rinse removes it, but the sprinklers keep adding more if they are not adjusted.
Can an oil stain come out of pavers?
Often it can be lightened, but not always erased. Coastal Clean Pressure treats oil as best effort and says deep oil can leave a lasting mark. Stallone's Pro Wash pretreats with a degreaser and lets it dwell. The sooner a drip is treated, the better.
What are the white patches on my pavers?
Often efflorescence, a mineral deposit that rises through the stone. Stallone's Pro Wash uses an acid based cleaner made for it, then neutralizes and rinses before sealing. Hazy old sealer can look similar, so a contractor checks which one you have.
Why do my pavers keep growing black or green patches?
Damp shade feeds algae and mildew. Safe Touch says humidity and river moisture drive it, and Coastal Clean Pressure uses algaecide on organic buildup. Open joints help growth return, so sand and sealer after a wash can slow it.
Does sealing stop new stains?
It helps by slowing how fast liquids soak in, but it is not stain proof. Coastal Clean Pressure notes that cleaning alone does not protect the surface, and a coat lasts only 2 to 5 years. Wipe fresh drips up soon, even on sealed pavers.
Can stains trapped under old sealer be removed?
Only after the sealer comes off. Stallone's Pro Wash lists dark trapped stains as a sign of failed sealer and strips it before resealing. Hydro Wash 360 prices stripping at $0.75 to $1.50 per square foot.
Which Northside areas does a stain removal contractor cover?
All the places below, each with its own local page. Check yours or call (904) 479-0914 to ask about a street that is not shown.
Which other paver services can I book in Northside?
Tired of looking at that stain?
Send a photo with the short form or call. A local contractor replies within 1 business day, usually much sooner, and the estimate is free.
Free, no obligation